Achtung! Bitte verwenden Sie die Firmware-Datei nur in Verbindung mit der aktuellsten CCU2/3 Version.
Please note: Only use the firmware file in connection with the latest CCU2/3 version.
Changelog:
Version 1.5.003 - 17/10/04
** Modification / Improvement
- Firmware modification for production change: Mounting the DR1 by robot instead by worker
Version 1.5.002 - 16/09/05
** Modification / Improvement
- After the incoming Data "CCU-Command" and "Configuration" the Device change for 5 s from WOR to RX-Mode.
Version 1.5.001 - 15/12/01
** Modification / Improvement
- Heating-Control in connection with a WTH shows occasionally two-point behavior -> fixed
Version 1.4.002 - 15/05/06
** Bug
- Bugfix at direkt pairing. Sometimes the parameter configuration after pairing goes wrong.
Version 1.4.001 - 14/10/20
** Bug
- Modification the radio data interpretation function, if check for CONFIG_SERIALNUMBER it is also necessary to
check the frame typ for FRAME_CONFIGURATION.
- Modification the direct link button-switch profile.
Version 1.3.001 - 14/04/24
** Bug
- Change in config_rt(...,...), parameter configuration is start at parameterposition 20.
The weekly program transfer to the partner was incorrect if the first timestep > 21:15 o'clock
- If party-mode bring into action, always the long status-message is send out instead of the
short status-message. The party-temperature is add as last byte at the long status-message.
Version 1.2.007 - 13/12/02
** Bug
- If all shutter-contacts cleared from device and window-open-temperature is active, temperature return from
window-open-temperature to old temperature.
- Internal window-open detection, send to partners.
- Central-Order "Boost", "Comfort", "Lowering", "Change Temperature" still running, if Party-Pre-Stage is active.
** ChangeRequest
- The operation mode still shows in lcd if a thermal control is known.
Version 1.1.001 - 13/09/16
** Bug
- Correction at takeover the actualtemperature and the settemperature, high-byte shift was not correct.
- Correction at takeover ccu-radio-order, if internal window-open is detected, it has to reset.
- Correction by the radio synchronization, if a thermal control is known, the device must synchronize to the
radio-datapacket actual/set-temperature.