C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-HAP - Access Point 2
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.0.44 - 2025-09-24
** Bugfix
- Background OTAU stops in a deadlock after it was paused
Version 1.0.42 - 2025-09-11
** Bugfix
- Support new server certificate
Version 1.0.40 - 2025-08-12
** Bugfix
- Other access point as next hop in rm response
- Wrong data in route request for a special address.
- Close connection with websocket connection delay always 14s
- Timeout for device routes learnd over backbone
** New Feature
- Add another root CA from Amazon.
Version 1.0.38 - 2025-08-04
** Bugfix
- GatewayToken set with netfinder not readable at configuration
- Time interval for the lookup request is not increased
- Send priority
- Answer at rm request without data
- Device op mode in rm response is not updated
- Not reachable device is not set to distance 7
- Distance at answer for RM request wrong
- Missing data in ICMP destiantion unreachable
** New Feature
- Add multicast to MAC Filter
Version 1.0.36 - 2025-07-11
** Bugfix
- The HAP2 sends ICMP destination unreachable with the wrong IP source address.
- The HAP2 does not send its cyclic status info frames.
- First signal of the boot sequence is not visible
Version 1.0.34 - 2025-07-10
** Bugfix
- The access point determines routes from radio frames that are not directly addressed to it.
- HAP2 blinkt nach Neustart der HCU
- Keine Verbindung zu den Geräten, wenn HAP2 die Verbindung übernimmt
- Wrong entry in Routing Table
- HAP2 bursted Tripple Burst Empfänger nicht an
- No answer for frame from sim device send to crrfd
Version 1.0.32 - 2025-07-07
** Bugfix
- Heating Controller Mode Frames to Multicast are not filtered.Â
- The AccessPoint does not respond to the cloud address if it is not directly connected.
Version 1.0.30 - 2025-07-03
** Bugfix
- All routes learned over backbone send in rm response
- Age counter not reset after icmp neighbor advertisement
- No answer to Status Request frames
- RSSI with 0x80 for rf device entry
- Network table entry with distance 0
Version 1.0.28 - 2025-06-20
** New Feature
--- END OF FILE ---