HMDeviceFirmware

C H A N G E L O G

Please note: Only use the firmware file in connection with the current software-version of the CCUx!

Device: HmIP-FROLL - Homematic IP Shutter Actuator for flush mount

Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany

** Improvement

Execute function "Enable operation within one end position to manually solve any error" only by a long button press

** Bugfix

If the device is restarted while overtemperature error the first statusinfo after restart doesn't signalize an error
A long keypress release leads to longer run time than the previous ones if the driving time is shorter than the long keypress repetition time
After a long keypress the actor runs longer than the set driving time
Section of virtual channels remains in "Move up/down reference run" if all three virtual channels are triggered by Direct Execution Command at startup
A command triggered by weekprogram or internal link is handled by the virtual channels although an error is active
Wrong evaluation of the event counter with multiple links between sensor and actuator

** Improvement

The level values 201 (last value) and 202 (don't care) to a virtual channel shall be directly passed through to the real channel
Changing driving directions with HmIP UP actuators via parameters
HmIP actuators with default links as button pair, should also have ABORT_EVENT_SENDING_CHANNELS as default in pairs
The time information telegram does not contain a note about the sommer / winter time change
Enable operation within one end position to manually solve any error
Switch from external to internal oscillator

** Bugfix

negative coordinates are not handled correctly
incorrect data type order for error status info message
default profile for long keypresses is useless
missing rf connection leads to stop of local operation at long key presses
bug in the creation of direct execution command for the weekprogram
actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover
HmIP radio shutter and blind actuators can be made to send DeviceInclusions again by a RetriggerDeviceInclusion Request, although this function was only intended for Wired devices
If the switch-on and switch-off times in the Easy Profile are set to "Not active" at the same time, the device hangs up
Shutters and blinds with longer driving times do not reach end position by short movements (very small values for MAX_TIME_FIRST_DIR)
Device does not work correctly after overtemperature was detected

** Improvement

added parameter DELAY_COMPENSATION to give the user the opportunity to use motors with greater delay time between switching the relay and start of motor movement.
new parameter to disable messages to the AC
new operation mode for wired devices
event counter validation expanded to range
all powerup parameters are supported now
Improve switch command functionality by new implementation of local loopback, adding command cancelation and using node sending functionality
Modify event counter check to meet current specification
If possible, send multicasts only to PARTNER_ALL_WIRED_DEVICES instead of to PARTNER_ALL_DEVICES

** First release

--- END OF FILE ---