C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-FDT - HomeMatic /IP
Dimmaktor Phasenabschnitt Unterputz
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 2.2.4 - 2023-11-10
** Bugfix
- Fixed error which leads to an boot failure under some special conditions.
Version 2.2.0 - 2023-06-08
** Bugfix
- The ON_MIN_LEVEL parameter is evaluated inconsistently for a DEC and a direct link.
** Improvement
- Add 2 configuration parameters for better dimming of LED lamps
Version 2.0.0 - 2022-12-06
** Bugfix
- Wrong evaluation of the event counter with multiple links between sensor and actuator
- Device sends answers-frame on a TimeInfo from AC to "any-router"-address
- In a switching group, only the first channels are switched on
- With the settings "Anzahl der auszulassenden Statusmeldungen = 0" and "Anzahl der auszulassenden, unveränderten Statusmeldungen = 0" the status is not transmitted in 2 to 3 minute intervals
- If the switch-on and switch-off times in the Easy Profile are set to "Not active" at the same time, the device hangs up.
- Wrong behaviour if a link partner is answering late
- A TimeInfo frame with ARR-Bit will not be answered
- Homematic IP actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover.
- device uses OFF_LEVEL of a direct link for direct execution command if level of direct execution is 0
- Wrong order of datatypes in the statusinfo frame
- The Weekprogram astro times doesn't work correctly with negative latitude or longitude
- After an OTAU reboot the inclusion requests are send to address 0x000000 sometimes
- Device does a reboot if factory reset is aborted
** New Feature
- Implement channel parameter for setting the Dimm-Min-Level.
- Switch-off ramp via central programs or automation.
- Support of HmIPW operation mode
- Rework AppSequenceCounter validation to a counter range check
- Support of systems and solutions without a central unit (installer solution)
** Improvement
- Switch from external to internal oscillator
- The time information telegram does not contain a note about the sommer / winter time change.
- Modify event counter check to meet current specification
- All PowerUp parameters, that are listed in list 3 of the device, must be supported.
- Changed default values for Powerup action parameters
Version 1.6.0 - 2017-11-21
** Bugfix
- A TimeInfo frame with ARR-Bit will not be answered
- Homematic IP actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover.
- device uses OFF_LEVEL of a direct link for direct execution command if level of direct execution is 0
- Wrong order of datatypes in the statusinfo frame
- The Weekprogram astro times doesn't work correctly with negative latitude or longitude
- After an OTAU reboot the inclusion requests are send to address 0x000000 sometimes
- Device does a reboot if factory reset is aborted
** New Feature
- Support of HmIPW operation mode
- Rework AppSequenceCounter validation to a counter range check
- Support of systems and solutions without a central unit (installer solution)
** Improvement
- All PowerUp parameters, that are listed in list 3 of the device, must be supported.
- Changed default values for Powerup action parameters
--- END OF FILE ---