C H A N G E L O G
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-DRBLI4 - Homematic IP Jalousieaktor für Hutschienenmontage â 4-fach
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.10.16 - 2023-06-16
** Improvement
- Funktion "Enable operation within one end position to manually solve any error" execute only with a long button press.
Version 1.10.14 - 2023-02-10
** Bugfix
- Reduced maximum number of partners to 4 for virtual channel B
Version 1.10.10 - 2022-12-02
** Bugfix
- Incorrect display visualization while local operation
Version 1.10.8 - 2022-11-15
** Bugfix
- Wrong evaluation of the event counter with multiple links between sensor and actuator
- Error in slat adjustment, slats move in the wrong direction
Version 1.10.0 - 2022-06-05
** Bugfix
- Error when the same position is called up several times
- A command triggered by weekprogram or internal link is handled by the virtual channels although an error is active
** New Feature
- Add possibilty to increase the time between two slats movements
** Improvement
- Switch from external to internal oscillator
- Change of driving time while long button press if the end position of the slats is reached
- Enable operation within one end position to manually solve any error
Version 1.8.2 - 2021-02-15
** Bugfix
- Section of virtual channels remains in "Move up/down reference run" if all three virtual channels are triggered by Direct Execution Command at startup
Version 1.8.0 - 2021-01-15
** Bugfix
- A long keypress release leads to longer run time than the previous ones if the driving time is shorter than the long keypress repetition time
- After a long button press, one channel will sporadically remain permanently supplied with 230 volts.
- After a long keypress the actor runs longer than the set driving time
- Device freezes, if undefined number of keypresses have been done
Version 1.6.0 - 2020-06-09
** Bugfix
- Device sends RequestConfigUpdate if received a MacAck from a LinkPartner
- The symbol for slat or shutter position remains in the display when switching to the input channels
** Improvement
- Changing driving directions with HmIP UP actuators via parameters.
- Add CHANNEL_OPERATION_MODE to switch between blind and shutter mode
Version 1.4.0 - 2019-09-24
** New Feature
--- END OF FILE ---