HMDeviceFirmware

C H A N G E L O G

Please note: Only use the firmware file in connection with the current software-version of the CCUx!

Device: HmIP-HAP Y7R - Access Point alte Bezeichnung: YOU-HAP-TTU

Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany

Version 3.0.18 - 2023-09-29

** Bugfix

• LEDs flash blue and after some time the communication to the cloud is disrupted.
• The update is interrupted after the web bootloader is downloaded.

Version 3.0.16 - 2023-06-14

** Bugfix

• Multicast routing problems
• LED sequence wrong after get data from lookup server

Version 3.0.12 - 2023-05-31

** Bugfix

• Problems at Update

Version 3.0.10 - 2023-04-21

** Bugfix

• Times between lookup requests become too large
• After reboot (power) sometimes both APs connected to cloud
• No lookup request after get a crrfd url that is too long
• Time at close connection with 0xffff wrong

Version 3.0.4 - 2023-03-22

** Bugfix

• Encrypted frames not send to cloud
• The access point gets stuck in an endless loop when an update is triggered by Netfinder, but no different version is available on the update server.
• Backbone frames payload length wrong

** New Feature

• New parameters for multicast filter
• Connection to the Cludserver, LockupServer and Updateserver via IPv6 possible
• Use return code when closing the WebSocket to the AP for indication if the route is still valid.

** Improvement

• send destination unreach with LHL = 7-x

Version 2.4.28 - 2022-09-16

** Bugfix

• The access point sends frames to the server that are too long.
• Replies to frames from the server are lost.

** Improvement

• Set different timeouts for backbone Routers and backbone devices

Version 2.4.24 - 2022-05-12

** Bugfix

• The HAP treis to send a frame to all wired devices via any router

Version 2.4.20 - 2022-04-06

** Bugfix

• The HAP will reboot if it does not receive a response to an Inclusion Accept.

Version 2.4.18 - 2022-03-29

** Bugfix

• The HAP sends a route management frame with its own address marked as unreachable.

Version 2.4.16 - 2022-01-26

** Bugfix

• The access points (HAP/DRAP) always send the Manufacturer Code 0x01 (EQ3) in the Inclusion Request, even with OEM variants.
• Device becomes continuous BURST transmitter in case of cloud failure
• HAP answers status frames (ARR) with burst frames.

** New Feature

• Forward backbone route management frames to the cloud server

Version 2.4.12 - 2021-07-27

** Bugfix

• The HAP tries to start a sequence number validation on all frames and takes the destination address of the receiving frame as the source address.

Version 2.4.10 - 2021-07-15

** Bugfix

• FactoryReset first button press duration too long

Version 2.4.8 - 2021-06-29

** Bugfix

• KeyVisual key press data for long button press wrong

** Improvement

• Stronger evaluation of the RSSI value during routing

Version 2.4.4 - 2021-04-28

** Bugfix

• HTTP client hangs, if the previous connection was not closed.
• The access point interrupts the connection to the cloud server if the lookup server has delivered an incorrect URL.
• Incorrect KeyVisual signal when the AP disconnects from the cloud server.
• Wrong priority for frames to event listener
• The AccessPoint sends a response to an empty RM V1 request.
• HAP glows permanently turquoise in a Singel HAP installation
• Factory reset is also possible during operation.
• Fehler bei nicht erreichbarer UpdateURL
• Invalid Tcp/IP packet in the web bootloader.
• Websocket connection delay is only applied after restart.
• HAP do not respond to IGMPv3 Membership Queries

** New Feature

• Request routing information over HAP protocol
• Live OTAU Service

** Improvement

• Improve system behavior when HmIP-HAP has no internet connection.

Version 2.2.24 - 2020-12-16

** Bugfix

• Frames can no longer be sent. The stack remains in the busy state.

Version 2.2.18 - 2020-10-07

** Bugfix

• OTAU: "Update Data" frames are send with burst.

Version 2.2.16 - 2020-09-23

** Bugfix

• Web-Bootloader cancels download of CoProzessor update.
• Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.2.12 - 2020-08-26

** Bugfix

• Multicast Readressing is also applied to INTERFACE_LOCAL/CLOUD

Version 2.2.10 - 2020-08-24

** Bugfix

• If the application is defective, an incorrect application version is reported to the update server.

** Improvement

• No longer route cyclic multicast frames.
• Flashing behaviour when the centre is not accessible (flashing turquoise)

Version 2.2.4 - 2020-08-07

** Bugfix

• The device-specific configuration can no longer be retrieved with Netfinder.

Version 2.2.0 - 2020-07-16

** Bugfix

• With the custom lookup address, the path is not processed correctly.

** New Feature

• Advanced Routing

** Improvement

• Change the default update URL
• Improve the connection to the cloud server.

Version 2.2.2 - 2020-07-24

** Bugfix

• Wrong app sequence counter in status response frame.

** Improvement

• Do not accept frames to AnyRouter if it is known that it is not routed.

Version 2.0.40 - 2020-10-05

** Bugfix

• Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 2.0.36 - 2019-10-16

** Bugfix

• The HAP crashes and restarts when DHCP is switched off.

Version 2.0.34 - 2019-10-11

** Bugfix

• If the ICMP ping fails, but the lookup server query succeeds, the KeyVisual color is not updated.
• The local bootloader returns a wrong value during the update.

Version 2.0.32 - 2019-10-08

** Bugfix

• No connection to the server is established and the KeyVisual lights up yellow permanently.

** Improvement

• To test the Internet connection, an attempt is made to send a ping to the lookup server; if the ping fails, an attempt is made to establish a connection anyway.

Version 2.0.26 - 2019-07-23

** Bugfix

• With the custom lookup address, the path is not processed correctly.
• HAP firmware stops after a FactoryReset is cancelled.
• FactoryReset has no timeout.

Version 1.2.26 - 2020-10-06

** Bugfix

• Download of update files will not start, if FIN,ACK from checkversion is not acked.

Version 1.2.12 - 2018-04-19

** Bugfix

• the configuration data will sometimes be corrupted during the update, causing a factory reset
• Look up server is requested just one time after startup

--- END OF FILE ---